جهاز تنفس صناعي من كلية الجبيل الصناعية ( JICVENT )


شرح لمخطط الدائرة الالكترونية التي سنعرضها في الخطوة القادمة :

The following circuit is used in our ventilator where one potentio – meter is connected to Arduino Uno board analog input A2 since A0 and A1 are reserved for current sensing of channel one and two of the driver , two push button are connected to digital inputs 2 and 6 for changing the breath frequency . the I2C LCD is going to be added in the next satge and will be connected to A4 and A5 which is the I2C Bus .

Finally, the motor shield is attached on top of the Arduino Uno board and its pins are directly connected to the Arduino without any wires.

تجدون هنا رابط الدائرة الإلكترونية للمشروع

أضف تعليق

X
تم إضافة المنتج إلى السلة بنجاح